Magnat Transforce 1200 Owner's Manual download pdf (Page 10)

Cut off frequency Subwoofer Coil L / min. Capacitor C /

cable diameter electric strength

60 Hz 380 mm 15 mH / 1.5 mm

470uF / 100Vdc

80 Hz 380/300 mm 12 mH / 1.0 - 1.5 mm

330uF / 100Vdc

90 Hz 300 mm 10 mH / 1.0 mm

330uF / 100Vdc

110 Hz 300/250 mm 8.2 mH / 0.7 - 1.0 mm

220uF / 100Vdc

130 Hz 250 mm 6.8 mH / 0.7 mm

220uF / 100Vdc

160 Hz 250/200 mm 5.6 mH / 0.5 - 0.7 mm

150uF / 100Vdc

The use of subwoofers leads to a multiple increase in the dynamics of your audio

system. To safeguard your tweeter systems, we recommend protecting these with an

additional protective condenser (100 - 200uF series-connected in front of the overall

mid-tweeter system).

THE FOLLOWING POINTS SHOULD BE HEEDED WHEN CHOOSING

COMPONENTS:

• Although core coils offer a good price-performance ratio, they also penetrate the

saturation region, which results in acoustic distortions. The coils should therefore

have as little ferrite / iron content as possible.

• Be sure to adhere to the recommended minimum cable diameter.

•With regard to condensers, electrolyte condensers with the highest possible

electric strength should be used.

• The components should not be mounted directly on the speaker. Secure the parts

with screws, cable ties and hot-setting glue. Keep the cable runs as short as

possible.

• The components are available from specialist electronic equipment dealers.

CABLES TO BE USED

To transport the output from the amplifier to the subwoofer efficiently and reliably, you

should bear in mind when selecting the speaker cable that 2 x 4 mm

gauge wiring is

required for cable lengths in excess of 3 meters. 2 x 2.5 mm

cable is sufficient for

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 52 53

No comments

Magnat Transforce 1200 Owner's Manual Page 10